Harmony Series (DY-BEF)
-
All Harmony DY-BEF Series Maintenance & Repair Guides
Please contact us at support@dynastyfireplace.com if you have questions regarding any of the guides below 1. Main control board and control box maintenance 2. Flame LED repair and maintenance 3. Flame motor repair and maintenance -
General Installation Instructions
Click the link below for the general installation instructions for the Harmony Series (DY-BEF) GENERAL INSTALLATION INSTRUCTIONS -
Click the link below for the Harmony BEF Series builder's guide: Harmony BEF45 Builder's Guide Harmony BEF57 Builder's Guide Harmony BEF64 Builder's Guide Harmony BEF80 Builder's Guide
-
Fireplace Maintenance - Post Installation
After your fireplace has been installed into your wall or feature wall, you can access everything in the fireplace from the front of the unit. All of the fireplace internal parts can be replace and serviced internally, and does not require access to the back of the fireplace. There is no need to... -
If your fireplace's heater shuts off after turning on for 10-15 seconds: 1. Ensure the temperature set on the remote is greater than the current temperature of your room (press and hold the Temperature button on the remote to change between °C and °F for 3 seconds). This will ensure the fireplac...
-
The Harmony BEF series can operate with just the flames on and heater off, or both on at the same time. Power draw for flame and flame bed ONLY operation: | | Flame + Flame Bed Only | Flame + Flame Bed Only | Flame + Flame Bed Only | Flame + Flame Bed Only | | --- | ---------------------- | --...
-
Download the user manual for the Harmony BEF series at the link below Harmony BEF User Manual
-
If you need a new remote or parts, you can purchase them through our online parts store at the link below: Dynasty Fireplaces - Online Parts Store
-
Select the link below to access the guide on how to repair and replace the flame motor driving the flames inside the Harmony BEF series. Please note this guide covers the Harmony BEF45, BEF57, BEF64, and BEF80 Repair and replace - Harmony BEF flame motor
-
Repair and Replace Flame LED Lights
Select the link below to access the guide on how to repair and replace the flame LEDs inside the Harmony BEF series. Please note this guide covers the Harmony BEF45, BEF57, BEF64, and BEF80 Harmony BEF - Flame LED Repair Guide -
Replacing the main circuit board (control box)
Please open the attached PDF below for full instructions: Harmony BEF Series - control box/main circuit board replacement -
Venting, Clearances & Combustables
Your new Harmony BEF electric fireplace may be installed virtually anywhere in your home. However, when choosing a location, ensure that the general instructions are followed. For best results, install out of direct sunlight. Ensure plug location has been determined before installation of the fir... -
The fireplace unit can be finished with ½ in. thick gypsum wallboard, or other facing material(s) not exceeding 9/16 in. thickness beyond thewall framing. The wallboard or facing material is finished up to the finishing stops on the face of the appliance. The front trim is installed so it overlap...
-
| PRODUCT | GLASS SIZE | | ------- | ---------- | | DY-BEF45 | δ5 * 1059 * 352, tempered glass | | DY-BEF57 | δ5 * 1359 * 352, tempered glass | | DY-BEF64 | δ5 * 1559 * 352, tempered glass | | DY-BEF80 | δ5 * 1959 * 352, tempered glass |